Cable & Connectors

Value. Resourcefulness. Innovation.

Cable & Connectors

Please note these camera products are for environmentally demanding applications.  These products, documentation, services etc. are created for use in heavy industrial process facilities primarily for viewing process applications to assist plant operators. All products are built to meet industrial standards and needs and to sustain environments normally destructive to common security camera products.

* Free consulting is available from the factory for all industrial camera applications.  Contact us for more information.

 

Video and camera control cables of various sizes and styles are available. Be careful when choosing cables. Video signal attenuation (signal loss) is very high with most coaxial cables. It is very important to use the proper cables sweep tested for minimum signal losses at the intended cable run distance. Otherwise, signal strength (image quality) may suffer severely. The cost difference of proper cables versus improper cables is small but the consequences of high loss cables (at the relevant frequencies of interest) can be severe. The usual solution is to remove and replace the inadequate cable. Contact the factory to be sure you are using adequate cables for the job!  Contact us for more information.
 
 
 
 
 
Coaxial cable connectors and adaptors: Many types are needed and Bass Electronics offers a very full range of products. Photo shows only a sample of the products available.   A miss-match of cable and connectors can cause wasted time on a job site. Contact the factory to be sure you are using adequate cable and the properly mated connectors for your project.  Contact us for more information.
 

 

Above is representative of our line of CGB Cable Gland Bulkhead sealing products available in all non-metallic, stainless steel, steel, aluminum, nickel plated brass etc.  Contact us for more information.

DTK-VSP-BNCA

Surge Protection

Bass Electronics Surge Protection Devices protect cameras and other connected components from lightning and other large currents induced through control signal cables. Single and multiple camera inputs are available, as well as units to protect PTZ data, 24, 110 and 220VAC circuits.  Contact us for more information.

VDA1X2, new model w aux power outputs, 9-2011 (21)

Signal Distributer: XDA1X2

Video signal distribution to two locations is provided by the Signal Distributor. With the XDA1X2 a video signal can be “split” into two directions, each having balanced and impedance matched signals for transmission up to 2000 ft.  Contact us for more information.

1-225-751-9455 • 2839 Needham Dr. Baton Rouge, LA 70814, USA

Flame Camera